No matter the occasion you'll find that our new line of Gina K. Designs products are perfect for every occasion! Proof in point... Designer Daniela Dobson created a sweet New Baby card and gift embellishment! Whether it's a little or a lot...it's always the perfect accent! Or so we think!
Special Delivery Card by Daniela Dobson
Therm O Web supplies:
Sticky Tape Mini Runner™
12″ Foil Laminator
Therm O Web 3D White Foam Squares Combo Pack
Therm O Web Zots™ Small
ZOTS™ ROLL • 3D
GINA K. DESIGNS PREMIUM CARDSTOCK 8.5″ X 11″• ISLAND DREAM
GINA K. DESIGNS FANCY FOILS™ 6″ X 8″ • GRASS GREEN
GINA K. DESIGNS (3) NESTED SQUARE DIES • SINGLE STITCH DESIGN • LARGE SET
GINA K. DESIGNS FOIL-MATES™ BACKGROUNDS • POLKA PARTY
GINA K. DESIGNS FANCY FOILS™ 6" X 8" • SWEET MANGO
Other Supplies:
About A Little Boy Photoplay Paper
Card Instructions:
Turn on the laminator.
1. Make a card base from green cardstock. Cut a piece of patterned paper slightly smaller than the card front and adhere it to the base using
Sticky Tape Mini Runner™. Cut out a card from patterned paper and adhere it to the card.
2. Die cut two squares from
GINA K. DESIGNS FOIL-MATES™ BACKGROUNDS • POLKA PARTY. Run the two squares through a laminator with
GINA K. DESIGNS FANCY FOILS™ 6" X 8" • SWEET MANGO and
GINA K. DESIGNS FANCY FOILS™ 6″ X 8″ • GRASS GREEN.
3. Make a pinwheel: cut from each corner towards center of square up to about 1/2″ from center. Punch 1/8″ hole in center of square. Fold each corner towards the center using
Therm O Web Zots™ Small as a temporary anchor. Secure center with a brad.
4. Attach pinwheel to the card using
ZOTS™ ROLL • 3D.
4. Adhere "special delivery" sticker to the card using
Therm O Web 3D White foam Squares. Tie twine into a bow and tuck it under the pinwheel using
Therm O Web Zots™ Small.
5. Create the second pinwheel, attach it to a paper straw using a brad. Use this as gift decor.
